NSE7_SDW-6.4 Certification Overview - [Jul 22, 2023] Latest NSE7_SDW-6.4 PDF Dumps [Q43-Q60]

Share

NSE7_SDW-6.4 Certification Overview - [Jul 22, 2023] Latest NSE7_SDW-6.4 PDF Dumps

The Best Fortinet NSE7_SDW-6.4 Study Guides and Dumps of 2023

NEW QUESTION # 43
Refer to the exhibits.


Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member and the static routes configuration.
If port2 is detected dead by FortiGate, which expected behavior is correct?

  • A. Subnets 10.0.20.0/23 and 172.20.0.0/16 are reachable only through port1.
  • B. Dead members require manual administrator access to bring them back alive.
  • C. Port2 becomes alive after one successful probe is detected.
  • D. The SD-WAN interface becomes disabled and port1 becomes the WAN interface.

Answer: A


NEW QUESTION # 44
Refer to the exhibit.

Based on the output, which two conclusions are true? (Choose two.)

  • A. Entry 1 (id=1) is a regular policy route.
  • B. There is more than one SD-WAN rule configured.
  • C. The all_rules rule represents the implicit SD-WAN rule.
  • D. The SD-WAN rules takes precedence over regular policy routes.

Answer: A,B


NEW QUESTION # 45
FortiGate is connected to the internet and is obtaining the IP address on its egress interlace from the DHCP server Which statement is due when FortiGate restarts and receives preconfigured settings to install as part of a zero-touch provisioning process?

  • A. The FortiGate cloud key added to the FortiGate cloud portal and FortiGate performs a factory reset before the restart
  • B. The zero-touch provisioning process completes internally, behind FortiGate
  • C. FortiDeploy connects with FortiGate and provides the initial configuration to contact FortiManager
  • D. FortiManager registers FortiGate after the restart and retrieves the existing configuration

Answer: C


NEW QUESTION # 46
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

  • A. diagnose sys virtual-wan-link service
  • B. diagnose sys virtual-wan-link member.
  • C. diagnose sys virtual-wan-link neighbor.
  • D. diagnose sys virtual-wan-link route-tag-list

Answer: C


NEW QUESTION # 47
Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

  • A. This traffic shaper drops traffic that exceeds the set limits.
  • B. FortiGate provides statistics and reading based on historical traffic logs.
  • C. Traffic being controlled by the traffic shaper is under 1 Kbps.
  • D. The debug output shows per-IP shaper values and real-time readings.

Answer: A,D


NEW QUESTION # 48
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )

  • A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
  • B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
  • C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
  • D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices

Answer: A,B


NEW QUESTION # 49
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

  • A. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
  • B. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
  • C. Check interval is the time to wait before a packet sent by a member interface considered as lost.
  • D. The dead member interface stays unavailable until an administrator manually brings the interface back.

Answer: B


NEW QUESTION # 50
Refer to the exhibits.
Exhibit A:

Exhibit B:

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate distributes traffic.
Based on the exhibits, what are two expected behaviors when FortiGate processes SD-WAN traffic? (Choose two.)

  • A. The first Vimeo session may not match the Vimeo SD-WAN rule because the session is used for the application learning phase.
  • B. The Vimeo SD-WAN rule steers Vimeo application traffic among all SD-WAN member interfaces.
  • C. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
  • D. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

Answer: A,D


NEW QUESTION # 51
Refer to exhibits.


Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

  • A. Port1 became dead 1ecause no traffic was offload through the egress of port1.
  • B. Both SD-WAN member interfaces have used separate SLA targets.
  • C. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
  • D. SD-WAN member interfaces are affected by the SLA state of the inactive interface

Answer: C


NEW QUESTION # 52
When attempting to establish an IPsec tunnel to FortiGate, all remote users match the FIRST_VPN IPsec VPN. This includes remote users that want to connect to the SECOND_VPN IPsec VPN. Which two configuration changes must you make on both IPsec VPNs so that remote users can connect to their intended IPsec VPN? (Choose two.)

  • A. Configure different Diffie Hellman groups.
  • B. Change the IKE mode to aggressive.
  • C. Configure different proposals.
  • D. Configure a unique peer ID.

Answer: B,D

Explanation:
https://kb.fortinet.com/kb/documentLink.do?externalID=10114


NEW QUESTION # 53
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )

  • A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
  • B. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
  • C. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
  • D. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

Answer: B,D

Explanation:
SD-WAN 6.4 Guide Page 158.


NEW QUESTION # 54
Refer to the exhibit

Which statement about the ADVPN device role in handling traffic is true?

  • A. Two hubs. 10.1.1.254 and 10.1.2.254, are receiving and forwarding queries between each other
  • B. Two spokes 100.64.3.1 and 10.1.2. 254 forward their queries to their hubs
  • C. This is a spoke that has received a query from a remote hub and has forwarded the response to its hub
  • D. This is a hub that has received a query from a spoke and has forwarded it to another spoke

Answer: D


NEW QUESTION # 55
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

  • A. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
  • B. There are separate virtual interfaces for each dial-up client
  • C. FortiGate created a single IPsec virtual interface that is shared by all clients
  • D. VPN static routes are prevented from populating the FortiGate routing table

Answer: B


NEW QUESTION # 56
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

  • A. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
  • B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
  • C. Port2 might become alive when a single response is received from an SLA server
  • D. Dead members require manual administrator access to bring them back alive

Answer: B


NEW QUESTION # 57
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

  • A. Configure SD-WAN rules interface preference.
  • B. Specify incoming interfaces in SD-WAN rules.
  • C. Specify outgoing interface routing cost.
  • D. Select SD-WAN balancing strategy.

Answer: A,D


NEW QUESTION # 58
Refer to the exhibit.

What must you configure to enable ADVPN?

  • A. On the hub VPN, only the device needs additional phase one sett
  • B. The protected subnets should be set to address object to all (0.0 .0. 0/0).
  • C. Each VPN device has a unique pre-shared key configured separately on phase one
  • D. ADVPN should only be enabled on unmanaged FortiGate devices.

Answer: B


NEW QUESTION # 59
Refer to exhibits.
Exhibit A.


Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?

  • A. Both SD-WAN member interfaces have used separate SLA targets.
  • B. Port1 became dead 1ecause no traffic was offload through the egress of port1.
  • C. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
  • D. SD-WAN member interfaces are affected by the SLA state of the inactive interface

Answer: A


NEW QUESTION # 60
......

Valid NSE7_SDW-6.4 Exam Updates - 2023 Study Guide: https://www.lead2passed.com/Fortinet/NSE7_SDW-6.4-practice-exam-dumps.html

Top Fortinet NSE7_SDW-6.4 Exam Audio Study Guide! Practice Questions Edition: https://drive.google.com/open?id=126CBKKxNsM2v_syqa2OpmOo7uJfMfbwf