[Feb 25, 2023] Latest 350-501 PDF Dumps & Real Tests Free Updated Today
350-501 Dumps With 100% Verified Q&As - Pass Guarantee or Full Refund
The Cisco 350-501 exam, Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) is meant to validate one's understanding of essential service provider solutions as well as processes associated with them. This test serves as a base for three certificates and covers all the areas an individual should be proficient in to climb the career ladder faster.
NEW QUESTION 11
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS. TDP must be used as the label protocol
- B. To support seamless MPLS, the BGP route reflector feature must be disabled
- C. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
- D. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
Answer: D
NEW QUESTION 12
What is a constraint of Cisco MPLS TE tunnel configurations?
- A. Tunnels cannot be configured over IP unnumbered links.
- B. With ISIS as an IGP. only older-style metrics are used.
- C. Tunnels cannot span multiple OSPF areas.
- D. QoS-aware tunneling is not supported.
Answer: A
Explanation:
NEW QUESTION 13
Refer to the exhibit:
This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to identify traps for SNMP polling
- B. It is used to create a sensor-group and has a list of YANG models for streaming
- C. It is used to create a subscription to specify the streaming interval
- D. It is used to identify MIB entries and has a list of YANG models
Answer: B
NEW QUESTION 14 
Refer to the exhibit. Which two statements about the IS-IS topology are true? (Choose two.)
- A. All four routers are operating as Level 1-2 routers.
- B. R1 and R4 are Level 2 neighbors.
- C. All four routers are operating as Level 1 routers only.
- D. All four routers are operating as Level 2 routers only.
- E. R1 and R2 are Level 2 neighbors.
Answer: A,B
Explanation:
Section: Networking
NEW QUESTION 15 
Refer to the exhibit. What is significant about the number 2 in the configuration?
- A. It represents the version of SNMP running.
- B. It dictates the number of sessions that can be open with the SNMP manager.
- C. It is the numeric name of the ACL that contains the list of SNMP managers with access to the agent.
- D. It indicates two SNMP managers can read and write with the agent using community string ciscotest.
Answer: C
Explanation:
Section: Automation and Assurance
NEW QUESTION 16
Refer to the exhibit:
With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
- A. 192.168.0.5
- B. 192.168.0.3
- C. 192.168.0.4
- D. 192.168.0.1
Answer: B
NEW QUESTION 17
ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, and ASN 65002 is allowed to advertise only 2001 :db8:aaaa::/48. An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions:
* Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied.
* Routes accepted into ASN 65001 must be assigned a community value of 65001:200.
Which configuration must the engineer apply to the ASN 65001 border router?
- A. Option B
- B. Option A
- C. Option C
- D. Option D
- E. Option E
Answer: D
NEW QUESTION 18
Which two steps must a service provider consider when adding multicast support to the existing MPLS L3VPN? (Choose two.)
- A. Bandwidth may be wasted on PEs as a result of only using the default MDT
- B. Using SSM for data MDT helps to minimize the number of group addresses needed in the core
- C. Forwarding customer multicast traffic only via the default MDT optimizes PE utilization
- D. Using default MDT results in a reduction of multicast routing states in the core
- E. All PEs must be configured as RPs inside of each customer VRF to minimize impact of the RPF lookups
Answer: A,D
NEW QUESTION 19
Drag and Drop Question
Drag and drop the methods of Cisco MPLS TE tunnel traffic assignment from the left onto their characteristics on the right.
Answer:
Explanation:
NEW QUESTION 20
Refer to the exhibit.
Which two topology changes happen to the IS-IS routers? (Choose two.)
- A. All four routers are operating as Level 1-2 routers.
- B. R1 and R4 are Level 2 neighbors.
- C. R1 and R2 are Level 2 neighbors.
- D. All four routers are operating as Level 1 routers only.
- E. All four routers are operating as Level 2 routers only.
Answer: A,C
NEW QUESTION 21
Refer to the exhibit:
Which statement supports QPPB implementation?
- A. QoS policies are identified in the MPLS forwarding table
- B. QoS policies use BGP to gain full coverage on the network.
- C. QoS policies rely exclusively on BGP attributes to manipulate traffic
- D. QPPB policies affect only egress traffic
Answer: C
NEW QUESTION 22
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION 23
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 1 and Router 2 advertise the route to 192.0.2.0/24 to all BGFD peers.
- B. All traffic is dropped
- C. Router 1 drops all traffic with a local-preference set to 150
- D. All traffic to 192.168.1.0/24 is dropped
Answer: D
NEW QUESTION 24
A network operator needs to implement PIM-SSM multicast configuration on customer's network so that users in different domains are able to access and stream live traffic. Which two actions must the engineer perform on the network to make the streaming work? (Choose two.)
- A. Configure a! leas! one MSDP peer on the network
- B. Enable PM dense mode on the device.
- C. Enable IGMP version 2 at the interface lever.
- D. Enable PIM sparse mode on the device.
- E. Enable IGMP version 3 at the interface level.
Answer: A,E
NEW QUESTION 25
Refer to the exhibit. After a networking team configured this MPLS topology, the supervisor wants to view MPLS labels to verify the path that packets take from router R1 to router R7 The team already Issued an ICMP ping to verify connectivity between the devices. Which task must the team perform to allow the supervisor to view the label switch path?
- A. Implement MPLS OAM to display the labels for each hop along the path
- B. Implement MPLS LDP to assign labels to all the routes in the transit path.
- C. Configure MPLS TE to display the labels in the stack between the head and tail-end routers
- D. Configure MPLS LDP Sync to sync labels from the routing table to the MPLS forwarding table.
Answer: A
NEW QUESTION 26
Refer to the exhibit. Which purpose of implementing NSF with this configuration is true?
- A. The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up
- B. The router uses NSF to load balance traffic on a routed EtherChannel
- C. The router uses NSF to reduce neighbor-relationship downtime during RP switchover
- D. The router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds
Answer: A
NEW QUESTION 27
Drag and drop the OSs from the left onto the correct descnpt.ons on the right.
Answer:
Explanation:
NEW QUESTION 28
A network engineer is configuring a router to send multicast traffic for the 239.10.10.10 group.
Which configuration must an engineer apply to the router to implement IGMP and forward the traffic?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION 29
What is the role of NSO?
- A. Provides public cloud services for customers that need Internet access.
- B. Provides network monitoring services for Layer 3 devices.
- C. Controls the turn-up of a device.
- D. Maintains data storage.
Answer: C
NEW QUESTION 30
Refer to the exhibit:
This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to set up configuration to poll network data
- B. It is used to create a streaming subscription with a 60-second interval
- C. It is used to enable gRPC
- D. It is used to create a streaming subscription with a 600-second interval
Answer: D
NEW QUESTION 31
......
2023 Valid 350-501 test answers & Cisco Exam PDF: https://www.lead2passed.com/Cisco/350-501-practice-exam-dumps.html
Pass Cisco 350-501 Exam With Practice Test Questions Dumps Bundle: https://drive.google.com/open?id=1GOm3E9Dpcnig9ak3uU3nVK_Qc0qkfEed
