Pass Your Cisco 350-501 Exam with Correct 452 Questions and Answers
Latest [Sep 07, 2024] 2024 Realistic Verified 350-501 Dumps
NEW QUESTION # 146
Refer to the exhibit. Which statement about the status of the neighbor relationship between R1 and R2 is true?
- A. The neighbor relationship is down because the two routers are configured with different area types
- B. The neighbor relationship is down because R2 is operating as a Level 1 router and the two routers are in different area
- C. The neighbor relationship is up because R2 is level 1 and level 2 router.
- D. The neighbor relationship is down because the two routers are in the same subnet.
Answer: B
NEW QUESTION # 147
Refer to the exhibit.
Refer to the exhibit. A network operator working for a private telecommunication company with an employee id: 7138: 13:414 just added new users to the network, which resides in VLANs connected to routers R1 and R4. The engineer now must configure the network so that routers R1 and R4 share routes to the VLANs, but routers R2 and R3 are prevented from including the routes in their routing tables. Which configuration must the engineer apply to R4 to begin implementing the request?
- A. pseudowire-class ciscotest
encapsulation mpls
service-policy output ciscotest - B. pseudowire -class ciscotest
encapsulation mpls
interface gigabitethernet 1/0/1
xconnect 192.168.1.1 101 pw-class ciscotest - C. pseudowire -class ciscotest
encapsulation mpls
interface gigabitethernet 1/0/1
connect neighbor 192.168.1.1 101 pw-class cisco - D. interface serial 2/0/0
frame-relay encapsulation
ip address 192.168.1.4 255.255.255.0
service-policy output ciscotest
Answer: B
NEW QUESTION # 148 
Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
- A. 192.168.0.4
- B. 192.168.0.5
- C. 192.168.0.1
- D. 192.168.0.3
Answer: B
Explanation:
Section: MPLS and Segment Routing
NEW QUESTION # 149
Which two PHY modes are available to implement an IOS XR Gigabit Ethernet interface interface? (Choose two.)
- A. WAN
- B. LAN
- C. WDWM
- D. MAN
- E. SONET
Answer: A,B
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-1/interfaces/command/reference/interfaces_cr41crs_chapter19.html
NEW QUESTION # 150
How much must the MTU be increased when configuring the 802.1q VLAN tag?
- A. 8 bytes
- B. 2 bytes
- C. 4 bytes
- D. 12 bytes
Answer: C
NEW QUESTION # 151 
Refer to the exhibit. Router 1 was experiencing a DDoS attack that was traced to interface gigabitethernet0/1.
Which statement about this configuration is true?
- A. Router 1 accepts all traffic that ingresses and egresses interface gigabitethernet0/1.
- B. Router 1 drops all traffic that ingresses interface gigabitethernet0/1 that has a FIB entry that exits a different interface.
- C. Router 1 accepts source addresses that have a match in the FIB that indicates it is reachable through a real interface.
- D. Router 1 accepts source addresses on interface gigabitethernet0/1 that are private addresses.
Answer: C
Explanation:
Section: Architecture
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_1/nx-os/security/configuration/ guide/sec_nx-os-cfg/sec_urpf.html
NEW QUESTION # 152
Refer to the exhibit.
A network engineer is implementing OSPF multiare
a. Which command on interface GO/1 resolves adjacency issues in the new area?
- A. ip ospf network point-to-multipoint
- B. ip ospf network point-to-point
- C. ip ospf network non-broadcast
- D. ip ospf network broadcast
Answer: B
Explanation:
In the context of OSPF multiarea implementation, adjacency issues can often be resolved by specifying the type of network on the interface. In this case, option B "ip ospf network point-to-point" is appropriate as it helps in forming OSPF adjacency over point-to-point links by allowing OSPF to use a simpler neighbor discovery process, which can resolve adjacency issues. Reference := Implementing and Operating Cisco Service Provider Network Core Technologies
NEW QUESTION # 153
Which fact must a network engineer consider when planning to deploy RSVP-TE FRR?
- A. The FRR backup tunnel reserves the total bandwidth of all protected tunnels
- B. PLR prefers FRR NHOP backup tunnels over NNHOP tunnels.
- C. FRR protects MPLS LDP and RSVP-TE LSPs.
- D. PLR prefers FRR NNHOP backup tunnels over NHOP tunnels.
Answer: B
Explanation:
RSVP-TE Fast Reroute (FRR) is a mechanism that provides protection switching for MPLS TE LSPs. The Point of Local Repair (PLR) will prefer to use a next-hop (NHOP) backup tunnel over a next-next-hop (NNHOP) backup tunnel when both are available. This preference is due to the fact that NHOP backup tunnels can provide faster rerouting around the failure point, minimizing traffic disruption and packet loss.
NEW QUESTION # 154
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION # 155
Refer to the exhibit:
This output is included at the end of an output that was provided by a device using NETCONF.
What does the code show?
- A. It shows NETCONF uses remote procedure calls.
- B. It shows the hostname of the device as rpc-reply
- C. It shows that the running configuration is blank
- D. It shows that the full configuration is being modeled by VANG
Answer: A
NEW QUESTION # 156
Refer to the exhibit:
A network engineer is implementing a BGP routing policy.
Which effect of this configuration is true?
- A. All traffic that matches acl10 is allowed without any change to its local-preference
- B. All traffic that matches acl10 is dropped without any change to its local-preference
- C. If traffic matches acl10, it is allowed and its local-preference is set to 300
- D. All traffic is assigned a local-preference of 30O regardless of its destination
Answer: A
NEW QUESTION # 157 
Refer to the exhibit. Which statement describes the effect of this configuration?
- A. It applies a service policy to all interfaces remarking HTTP traffic.
- B. It matches HTTP traffic for use in a policy map.
- C. It modifies the default policy map to allow all HTTP traffic through the router.
- D. It creates an ACL named WEB that filters HTTP traffic.
Answer: B
Explanation:
Section: Services
NEW QUESTION # 158
A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements:
* Management protocols must be marked with DSCP AF class 2 w4h low drop probability.
* Monitoring protocols must be marked with DSCP AF class 1 with low drop probability.
* All remaining traffic must be marked with a DSCP value of 0.
Which configuration must the engineer implement to satisfy the requirements?
A)
B)
C)
D)
- A. Option D
- B. Option C
- C. Option B
- D. Option A
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/guide/nexus1000v_qos/qos_6dscp_val.pdf
NEW QUESTION # 159
An engineer is implementing a Cisco MPLS TE tunnel to improve the streaming experience for the clients of a video-on-demand server. Which action must the engineer perform to configure extended discovery to support the MPLS LDP session between the headend and tailend routers?
- A. Configure an access list on the interface to permit TCP and UDP traffic.
- B. Configure the interface bandwidth to handle TCP and UDP traffic between the LDP peers.
- C. Configure a Cisco MPLS TE tunnel on both ends of the session.
- D. Configure a targeted neighbor session.
Answer: C
Explanation:
https://community.cisco.com/t5/mpls/mpls-te-tunnel-targeted-ldp-session/td-p/2863558
NEW QUESTION # 160
Refer to the exhibit:
This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to create a streaming subscription with a 600-second interval
- B. It is used to enable gRPC
- C. It is used to create a streaming subscription with a 60-second interval
- D. It is used to set up configuration to poll network data
Answer: C
NEW QUESTION # 161
Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?
- A. routing configuration mode
- B. mode BGP address-family configuration mode
- C. BGP neighbor configuration
- D. global configuration mode
Answer: D
NEW QUESTION # 162
Which additional feature does MPLS DiffServ tunneling support?
- A. matching EXP and DSCP values
- B. interaction between MPLS and IGP
- C. PHB layer management
- D. using GRE tunnels to hide markings
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_te_diffserv/configuration/15-mt/mp-te-diffserv-15-mt-book/mp-diffserv-tun-mode.html
NEW QUESTION # 163
......
Get 2024 Updated Free Cisco 350-501 Exam Questions and Answer: https://www.lead2passed.com/Cisco/350-501-practice-exam-dumps.html
Pass 350-501 Exam Updated 452 Questions: https://drive.google.com/open?id=1bHsSPK8OjclfScKTX1CR7Fi2L-iLrU9l
