New Lead2Passed NS0-176 Exam Questions| Real NS0-176 Dumps Updated on Nov 19, 2021
NS0-176 Braindumps – NS0-176 Questions to Get Better Grades
NetApp NS0-176 Exam Topics:
| Section | Objectives |
|---|---|
| FlexPod Configuration | - Describe how to install and configure the FlexPod components - Describe how to configure neworks in a UCS solution - Describe how to configure SAN boot in a FlexPod solution - Describe knowledge of how to configure a service profile - Demonstrate knowledge of how to configure storage in a FlexPod solution - Demonstrate knowledge of how to configure Cisco Nexus switches |
| FlexPod Design | - Describe the storage components supported in FlexPod - Describe the networking components supported in FlexPod - Describe the compute components supported in FlexPod |
| FlexPod Troubleshooting | - Demonstrate how to perform FlexPod troubleshooting |
| FlexPod Administration | - Demonstrate knowledge of how to administer FlexPod solutions according to FlexPod best practices - Describe FlexPod management applications - Demonstrate knowledge of how to install and upgrade the FlexPod solution |
| Information Gathering for FlexPod Solutions | - Describe the main FlexPod components |
NEW QUESTION 36
When connecting the Nexus 1110-X to the Nexus switch, what Spanning Tree port type is used?
- A. Network
- B. Edge
- C. Edge trunk
- D. Normal
- E. Trunk
Answer: C
NEW QUESTION 37
Refer to the exhibit.
What management tool may be used for creating virtual machines?
- A. Hyper-V Manager
- B. System Center Virtual Machine Manager
- C. System Center Orchestrator
- D. MMC
Answer: A
NEW QUESTION 38
Exhibit:
Which hardware component is shown in the exhibit?
- A. VIC
- B. IOM
- C. GEM
- D. Fl
Answer: B
NEW QUESTION 39
A Cisco UCS chasis has two power suppliers connected to one PDU and two power supplies connected to another PDU. You would like to protect against the failure of one entire PDU.
In this scenario, which power policy should you configure in UCS Manager?
- A. grid
- B. redundant
- C. N+2
- D. N+1
Answer: A
NEW QUESTION 40
While working on a performance related issue on your FlexPod solution, you notice an unequal distribution of traffic over the physical interfaces of a four port vPC between two Nexus 5000 switches. You would prefer a more even traffic distribution.
Which command would you use to accomplish this task?
- A. ~lacp system-priority~
- B. ~port-channel load-balance ethernet~
- C. ~lacp rate fast~
- D. ~hardware multicast hw-hash~
Answer: B
NEW QUESTION 41
Which two technologies must be deployed for a Cisco Nexus 9000 ACI design? (Choose two.)
- A. APIC
- B. LACP
- C. spine switch
- D. VSM
Answer: A,C
NEW QUESTION 42
You want to verify that you have configured Multipath HA correctly for all of the attached disk shelves on a NetApp cluster.
Which two commands would you execute from the cluster CLI prompt to accomplish this task? (Choose two.)
- A. node run -node * storage show disk -p
- B. sysconfig -a
- C. node run -node * sysconfig -a
- D. node run -node * -command disk show
Answer: A,B
NEW QUESTION 43
What is the correct flow control setting for the intercluster ports on a NetApp cluster?
to 50% cashback.
- A. switched cluster = set to match the setting on switch port switchless cluster = none
- B. switched cluster = none switchless cluster = full
- C. switched cluster = full switchless cluster = none
- D. switched cluster = none switchless cluster = none
Answer: A
NEW QUESTION 44
Where are log files located on a NetApp node?
- A. /mroot/etc/log/mlog/
- B. /mroot/etc/crash/
- C. /letc/log/crash
- D. /log/core/
- E. /etc/mlog/
Answer: A
NEW QUESTION 45
How many ACTIVE SPAN sessions exist on a Fabric Interconnect?
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
Answer: C
NEW QUESTION 46
Your company is looking for a small remote office infrastructure to deploy to your 30 remote sites. You are asked to write deployment procedures for each site. Your goal is to have each site deployed in less than a day.
Which tool will help you accomplish your goal?
- A. OnCommand Insight
- B. UCS Director
- C. OnCommand System Manager
- D. UCS Manager
Answer: B
NEW QUESTION 47
An administrator is configuring a Flexpod Datacenter solution. The UCS service profiles will use FCoE connectivity to the NetApp cluster.
Which pool is needed to configure the vHBA templates?
- A. MAC pool
- B. WWPN pool
- C. IQN pool
- D. WWNN pool
Answer: B
NEW QUESTION 48
Which two statements about HA pairs in a NetApp cluster are true? (Choose two.)
- A. In the event of a storage failover, the surviving node always takes over the partner's data LIFs.
- B. In the event of a storage failover, the surviving node provides read/write access to the partner's disks until the failed node becomes available again.
- C. Non-disruptive aggregate relocation can be performed between HA pairs without a takeover and giveback.
- D. HA pairs in the same chassis are not connected to each other through an HA interconnect.
Answer: A,B
NEW QUESTION 49
Under which tab in UCS Manager would you create a boot policy?
- A. Servers
- B. SAN
- C. LAN
- D. Equipment
Answer: A
NEW QUESTION 50
Exhibit:
Referring to the exhibit, which two diagrams show the correct way to cable a new NetApp clustered Data ONTAP cluster with two nodes? (Choose two.)
- A. IV
- B. III
- C. I
- D. II
Answer: B,D
NEW QUESTION 51
Which three are types of Storage Virtual Machines? (Choose three.)
- A. intercluster
- B. flex
- C. data
- D. vFiler
- E. node
- F. cluster
Answer: C,E,F
NEW QUESTION 52
Which type of pools do you need to create vHBA templates?
- A. WWPN
- B. IQN
- C. MAC
- D. WWNN
Answer: A
NEW QUESTION 53
Which LIF role is used for SnapMirror traffic on a system running clustered Data ONTAP?
- A. intercluster
- B. interconnect
- C. node-management
- D. cluster-management
Answer: A
NEW QUESTION 54
Which three elements are included in a UCS service profile? (Choose three.)
- A. identity information
- B. switch configuration
- C. server definition
- D. volume layout
- E. firmware revisions
Answer: A,C,E
NEW QUESTION 55
You have a FlexPod solution with Cisco 6296UP Fabric Interconnects. You currently have a direct-attached AFF8040 system using FCoE for storage connectivity. You would like to reconfigure the FlexPod so that the storage is connected through the upstream switches.
Using UCS Manager, which two steps would you perform to accomplish this task? (Choose two.)
- A. Configure the FI ports with the FCoE Uplink role.
- B. Using the Configure Unified Ports wizard, change the port types to FC.
- C. Using the Configure Unified Ports wizard, change the port types to Ethernet.
- D. Configure the FI ports with the Uplink role.
Answer: B,D
NEW QUESTION 56
Your primary VSM needs to be edited, rebooted, or migrated. You need to initiate a manual switchover to your standby VSM.
What command will allow this to occur?
- A. System standby
- B. vsm switchover
- C. Standby activate
- D. System switchover
Answer: D
NEW QUESTION 57
For a 'boot from SAN' configuration, which two features must be enabled? (Choose two)
- A. FCSP
- B. FCOE
- C. UDLD
- D. VPC
- E. FC
- F. NPIV
Answer: B,F
NEW QUESTION 58
Which two are correct about VSAN configuration within UCS Manager? (Choose two)
- A. In addition to SAN tab, VSANs can be configured under UCSM Server tab as well.
- B. VSAN can be configured as fabric interconnect specific.
- C. We can delete VSAN 1.
- D. VSAN can be configured as a global parameter.
- E. VSAN IDs 3840-4079 are not available regardless of the Fabric Interconnect mode.
- F. VSAN ID and FCoE VLAN ID have to match.
Answer: B,C
NEW QUESTION 59
Which pool of addresses is created under Servers tab in UCS Manager as part of the Service Profile creation process?
- A. WWPN Pools
- B. UUID Suffix Pools
- C. MAC Pools
- D. WWNN Pools
Answer: B
NEW QUESTION 60
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?
- A. Cisco UCS Central
- B. Cisco UCS Sizer for Enterprise Applications
- C. Microsoft Assessment and Planning (MAP) Toolkit
- D. Cisco Resource Comparison Tool
Answer: C
NEW QUESTION 61
......
NS0-176 Exam Dumps - Try Best NS0-176 Exam Questions: https://www.lead2passed.com/NetworkAppliance/NS0-176-practice-exam-dumps.html
